How to Make Ribs

Posted on

OK a quick tutorial on how to make wooden wing ribs.

Step 1: If you want to do this the easy way…. but a wing rib kit from Steen (if you are building a Skybolt) as well as the rib jigs. If you dont want to buy the gussets, capstrip and jigs – thats fine you can make them, but man that would take a lot of time

Step 2: From here I am using a rib kit and the jigs. Next step is to lay some Glad Bake into the jig. This stops the glue sticking. Then cut out the gussets from the sheets that come with the kit. One sheet per rib. It does take a bit of tim to figure out which of the 6 jigs to use. Once you have done a couple you can figure that out. You will notice in the picture below that the nose rib is already cut – another time saving from the kit.

 

img_0148

 

Step 3: Trim Capstrip and lay it in. You will notice that you need to notch the fronts of the top and bottom cap strip to lock it into the nose rib infill. Trim the rest. I do the verticals first then the angles.

Step 4: Glue. Now once its laid in, I pull it all apart again to start the glueing process. I do one rib in about 35 minutes. Each piece needs to have glue added in the right spot in the joint starting with the bottom gusset, then lay the cap strip in then add the top gussets.

Step 5: Lay another sheet of Glad Bake on top of the ribs, ready to sandwich between the bottom of the jig and the perspex overlay

img_0152

Step 6: Place the top on and clamp to hold flat. Once clamped drying only takes about 12 hours.

img_0153

Step 7: Once dried and removed from the jig, there is quiet  bit of sanding that is required. What I have done is use a file with the jig in a vice to file out the spar location holes, then used a linisher to sand any glue on the outside of the rib. Any further removal of glue for example on the cap strip is done with a file.

Step 8: Once all of the ribs are dry I then joined them up to profile sand. This takes quite some time to get the profile of the ribs together so they are the exact same size and profile

img_0156

Step 9: All done and ready for placement onto the spars

img_0157

 

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s